Veteran Garage Door Repair | Keller TX | 817-769-8488

Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might find that your garage door opener has actually been giving you problems, so you need to fix it. You can repair it by replacing a circuit board, a photo-eye sensing unit, the primary drive equipment, or the set-limit buttons. You can additionally inspect if the safety and security sensing units are functioning correctly.

Changing a circuit card

Replacing a circuit board for your garage door opener calls for a couple of actions and devices. First, you need to shut off the circuit breaker and disconnect any type of wires. Next off, open up the circuit board cover. This will certainly help you to detect the problem and also identify if you require a brand-new board. Next, eliminate the old board and its cable adapters.

You can then continue to change the circuit card. The replacement process is very easy and takes about 10 mins. A new motherboard will cost about $80. To safeguard your new circuit board from power surges, you can buy a rise guard.

Changing a photo-eye sensor

Changing a photo-eye sensor can be a relatively easy job. Initially, get rid of the sensor from the door and also ensure it is located appropriately. If the sensing unit is angled by any means, it may not be obtaining the right signal, which might be causing the strobe lights. If you see that the photo-eyes are out of positioning, you might require to have a professional come and also fix the issue.

The photo-eye sensing unit contains two items that mount on the outside of the door tracks and towards the floor. The photo eyes will certainly have a little LED light and must be strong in color. If the light is blinking, its most likely the photo-eye is malfunctioning and also will require to be changed.

Replacing a main drive equipment

To replace a garage door opener main drive equipment, start by removing the cap from the chain sheave. Next off, eliminate both screws holding the drive gear to the sprocket assembly. Now, you can loosen the 3 stress pins. Squeeze them from both sides and afterwards eliminate them. After that, separate the three cords from the garage door opener electric motor. These wires should be white, red, and also blue.

Once you have removed the old gear, set up a new one. Make sure to oil it well. Put the new equipment right into the shaft, ensuring to align the placing openings. Make sure the equipment as well as gear assembly are located properly to guarantee smooth procedure. Next off, make use of a hammer and also a nail to drive a pin right into the new equipment.

Changing the set-limit switches

The initial point you must do if your garage door is not functioning properly is to check the set-limit switches. You may require to change them to make sure that the door shuts earlier or stops prior to it reaches the flooring. You can examine this by checking out your garage doors guidebook or online.

To adjust the set-limit buttons, youll require a screwdriver or outlet. Change the handle clockwise or counterclockwise till the door moves up and stops, or decreases its range. To look for correct travel range, gauge the gap from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, USA

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488 Veteran Garage Door Repair | Keller TX | 817-769-8488
Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top